Technical Description
The BeamRay Therapy Device

Frequency Range
Tested 0.01 Hz - 50 MHz

Frequency Wave and Sideband
Transmits all ETDFL frequencies using multiple infrared light spectrums when connected to an RDPV4 machine. All BeamRay MOR carrier wave and RF frequencies are reproduced through the Positive and Grounded areas of the device with +99%† efficiency.

Brightness Settings for the BeamRay Mats using the BeamRay Controller
To begin treatment, set the BeamRay Controller to the LOW illumination level. Gradually increase the intensity to HIGH for enhanced recovery protocols. Ensure the targeted area remains fully exposed while using the BeamRay Mats. If the light feels too intense, revert to the LOW setting. For individuals with sensitive skin, an optional light T-shirt can be worn, with the Light Mat placed over the fabric for additional comfort.

Brightness Settings for the BeamRay Mats with the RDPV4 Controller
To adjust the illumination level, set the RDPV4 Controller to 12.5 V DC if the intensity is too high. The available voltage settings are 12.5 V DC for the lowest, 14.5 V DC for the medium, and 17.5 V DC as the maximum default setting, which is recommended for cancer treatments. If the light feels too intense, return to the lower setting. For those with sensitive skin, it is advisable to wear an optional light T-shirt, with the Light Mat placed over the fabric for added comfort.

Clinic Use and Cleaning
For multi-user or clinic settings, clean the mats surface after each use with a cloth. Avoid using alcohol directly on the surface. Do not machine wash the mats, as this will damage the electronics.